Like I said before, These mittens are a glove-mitten combo and have a split that separate your pinkie and ring finger from your middle and index fingers. While wearing them you could do a Vulcan salute or pretend you have three fingers like a Sontaran. You could also use the handbrake on your bike while still holding on to the handle! Amazing!
Materials:
Small Knifty Knitter blue round loom (24 pegs)
Approximately 75 yards super bulky yarn (I used Lion Brand Wool-Ease Thick & Quick)
Instructions:
1. Cast on using your method of choice.
2. Rounds 1 - 10: k1,p1.
3. Rounds 11 - 24: knit all stitches.
4. To make the thumb: knit pegs 1-4 (32 rows).
5. Rounds 25 - 36: knit all stitches.
6. Place markers/tape between pegs 8/9 and between pegs 20/21.
7. Knit to marker, turn Knit to other marker (12 rows).
8. From peg 21: turn, knit 4 pegs; turn, knit to marker; turn, knit 2 pegs; turn, knit to marker.
9. Cut yarn leaving a short tail.
10. Knit pegs 8-5; turn, knit to marker; turn, knit 2 pegs; turn, knit to marker.
11. Bind off this half of the mitten.
12. Knit pegs 9-20 (10 rows).
13. From peg 9: turn, knit 4 pegs; turn, knit to marker; turn, knit 2 pegs; turn, knit to marker.
14. Cut yarn leaving a short tail.
15. Knit pegs 20-17; turn, knit to marker; turn, knit 2 pegs; turn, knit to marker.
16. Bind off this half of the mitten.
17. Stitch sides of thumbs and around finger sections.
18. Enjoy!
Update: I closed comments because I was getting way too much spam!
No comments:
New comments are not allowed.